克尔介质中超连续谱的产生与自聚焦的抑制

 从（3+1）维非线性薛定谔方程出发，理论上分析了超短脉冲频谱展宽与自聚焦的影响因素。分析得出：通过改变泵浦光的功率和光束口径，可以实现光谱的极大展宽并避免自聚焦成丝。数值模拟了小口径强泵浦光束在BK7玻璃中的传输过程并进行了实验验证。模拟结果显示在超连续谱产生的同时小尺度调制被完全抑制。实验结果表明：降低泵浦光功率，使光束不会因为全光束自聚焦而发生塌陷，同时还能控制除自聚焦外的其它非线性效应，进而改善近场光束质量。由于自相位调制是超短超强脉冲产生超连续谱的重要机制之一，需要维持传输过程中的泵浦光功率，由此最佳的入射光功率应选在全光束自聚焦功率阈值附近。     

Resonance method for IR sensing

A highly sensitive method for infrared radiation detection based on thermal resonance in an active bolometer is set forth. An active bolometer is a self-oscillating system consisting of an IR-sensitive cell in a feedback circuit of an adjustable proportional controller. The analysis of an active bolometer autonomous (dark) dynamics reveals that with a generalized gain factor A variation the system evolves from relaxation type towards oscillating and self-oscillating type. When A=A_c, where A_c is a critical value of the generalized gain factor A, the steady state loses stability through self-excited thermal oscillations. The resonance in a system weakly perturbed by IR radiation modulated at self-oscillation frequency q₀[1+exp(iω_ct)] is considered. It is shown that in a small precritical vicinity =(A−A_c)/A_c of the gain factor the amplitude of forced thermal oscillations is proportional to q₀/A_c. The D^* calculation reveals that the detection power of a passive (A=0) bolometer increases with feedback introduction by a factor of 1/||. The detection powers of feasible versions of an active bolometer are compared.     

激光除锈过程的实时监测技术研究

对激光除锈过程中的实时监测技术进行了实验研究,结果表明:除锈过程中产生的声波强度会随着表面清洁度的变化而发生明显的变化,声波信号包含了除锈过程中的大量信息,可作为激光除锈实时监测的基本信号.     

C-Fe chains due to segregated carbon impurities on Fe(1 0 0)

Bulk carbon impurities segregate at the Fe(1 0 0) surface and, upon thermal annealing, can form metastable surface phases with local and long range order and peculiar electronic properties. We present a surface science study of C-segregated Fe(1 0 0) with scanning tunneling microscopy, angle resolved photoemission, and ab initio calculations of the surface structure and electron states. In particular the c(3√2 × √2) structure, observed for 0.67 atomic layers of C segregated at the iron surface, is found to be due to self-organized carbon stripes made of zig-zag chains. The strong hybridization between C and Fe was observed in ARPES spectra.     

塑料光学元件的清洗、镀膜和胶合

各种塑料光学元件在光学系统中的应用越来越广泛。作为光学元件,必然涉及清洗、镀膜和胶合等工艺技术问题。本文就塑料光学元件的这三个技术作一介绍。     

小间隙高放大多丝室及其放电机制

对以强猝灭气体工作的小间隙多丝室及其放电机制进行了研究,实验表明,因为工作在饱和模式区,这种室同时具有很高的气体放大和相当快的时间特性.文中探讨了放电机制,雪崩中空间电荷效应以及电离光子的产生和作用是重要的因素,而其中后一因素又受到强猝灭气体的抑制.     

聚丙烯酰胺/醋酸铬与聚丙烯酰胺/酚醛胶态分散凝胶的纳米颗粒自组织分形结构

采用原子力显微镜 ,分别对无机交联体系聚丙烯酰胺 Cr3+ 和有机交联体系聚丙烯酰胺 酚醛胶态分散凝胶的微观结构进行了显微图像分析 .发现无论是在有机还是无机交联体系中 ,也无论聚丙烯酰胺和交联剂浓度如何变化 ,在微米尺度上最终形成的都是具有自相似性的树枝状分形图像 ,在更小尺度上则发现单个小树杈分形体都是由纳米级的颗粒紧密堆积而成 .在所研究的胶态分散凝胶体系中 ,树枝状分形结构的形成及其具体的形态取决于聚丙烯酰胺的浓度 ,而交联剂的有无及其多少只对树枝状凝胶分形的几何形态产生一定影响 .实验结果还表明纳米级 (≤ 10 0nm)的胶体颗粒构成的分形结构的凝胶其弹性模量G′比微米级的高出一个数量级 .且粒子尺度越小 ,则凝胶的力学稳定性越强     

辣根过氧化物酶活性膜结构及生物电催化性能

通过分子沉积法研究了在聚对苯二甲酸乙二醇酯（PET）表面及金电极表面组装辣根过氧化物酶（HRP）/聚对苯乙烯磺酸钠（PSS）多层生物活性膜，用原子力显微镜(AFM)研究了组装膜的表面形貌，并研究了组装膜的形貌、粗糙度和活性关系.应用循环伏安法（CV）研究了组装HRP膜后电极对H2O2的电化学催化还原作用.实验发现，采用亚甲基蓝（MB）溶液为介质，在H2O2浓度为0.2～5.0 mmol•L－1时，其响应电流对H2O2浓度变化基本呈线性.     

水溶性含C_(60)聚电解质的制备及其与重氮树脂自组装膜AFMFFM的初步研究

通过BPO引发的溶液聚合 ,合成了水溶性的星状C6 0 苯乙烯 苯乙烯磺酸钠的三元共聚物 [Star shapedC6 0 poly(St SS) ],运用自组装技术 ,在水溶液中 ,含C6 0 的三元共聚物与重氮树脂 (Diazoresin)通过正负离子间的吸附力在云母基片上交替一层一层有序地组装成固体膜 .自组装膜经紫外光幅照反应 ,通过重氮基的分解 ,层间连接的离子键转变成共价键 ,从而增加薄膜的稳定性和堆砌密度 .用原子力显微镜 摩擦力显微镜(AFM FFM)考察了C6 0 在膜中的承载作用及比较不同链结构、不同链长、不同层数自组装膜的表面形貌和微摩擦性能 .初步的研究结果显示了聚合物薄膜的微摩擦性能与聚合物的化学结构、链长和膜的层数有密切关系     

The study of electron beam flue gas treatment for coal-fired thermal plant in Japan

The fundamental research work with simulated coal-fired flue gas was performed in JAERI to get basic data for electron beam treatment of flue gas from thermal power plants in Japan. The standard condition of the experiments was set to be the same as that of next large scale pilot test in Nagoya. The concentrations of NO_x and SO_x were 225 ppm and 800 ppm, respectively. The temperature of the system was 65°C. The effect of multiple irradiation was observed for NO_x removal. The target SO_x and NO_x removals (94% and 80%, respectively) with low NH₃ leakage (less than 10 ppm) were achieved at 9 kGy irradiation with 0.9 NH₃ stoichiometry during 7 hours continuous operation. The facility for the pilot plant (12,000 Nm³/hr) has just built at the site of Shin-Nagoya power plant of Chubu Electric Power Company and will be started in full operation in November 1992.